would this work

by **pippoodle** Sun 26 Jul 2009 - 21:04

I've got lots of jars for my babies but my mate down the end of the road said he can make me something like this but bigger sections
[You must be registered and logged in to see this link.]

What size section would be minimum for housing baby boys - would be nice to keep them in the main tank so they have nice clean filtered water all the time with no temp fluctuations

cheers sarah

by **Vandraco aka Bronzecat** Sun 26 Jul 2009 - 21:41

Look for around 5/6 inches long x 4/5 inches deep.

The only thing is, I have heard that the ones you have linked too have a slight danger. I have heard that the suction cups have slipped meaning container has slipped under water. The lid has stuck on and the betta basically drowned. Worth bearing in mind.

by **pippoodle** Sun 26 Jul 2009 - 21:43

the ones my mates on about making will have wire hinges on to hook over the outside of the tank and also use the suckers on the inside
i would hate any of the to drown

by **Vandraco aka Bronzecat** Sun 26 Jul 2009 - 21:44

That should work fine thumbup

by **pippoodle** Sun 26 Jul 2009 - 21:48

cos the suction things from ebay are

12.6" width
3.9" deep
2.4" long

So i'm thinking if he did mine as below would that be suitable

16" wide (4" for each bettas)
4" deep
3" long

by **Vandraco aka Bronzecat** Sun 26 Jul 2009 - 21:53

Will be fine for little uns :D

by **pippoodle** Mon 27 Jul 2009 - 17:00

ah that'll be good them will get him onto it Smile

thanks hun

by Sponsored content

would this work

would this work

Re: would this work

Re: would this work

Re: would this work

Re: would this work

Re: would this work

Re: would this work

Re: would this work